One Arm Bandit Restoration Project
Refurbishing One Arm Bandit Mechanisms
A major part in restoring these machines to their former glory was getting the reel mechanisms up and working. Some of the reel mechanisms appeared to be in good order considering the time the machines had been out of use. However many of them were seized, missing parts and extremely rusty. In a few of the machines in particular, the reel mechanisms had made home to mice and rats over the years so were in a very bad state of decay.
The reel mechanisms were completely stripped; every part was cleaned by hand with a wire brush and the more heavily corroded components were stripped back using the sand blaster. Many of the components were so bad they had to be replaced for new ones. On a few of the mechanisms which were in better condition parts such as the pay-out slides, pay-out forks, and clock workings just required a lot of cleaning and some slight adjustments. Every moving part was re-greased and the mechanisms were then re-assembled and tested.
The coin escalators were also in varied conditions but as with the reel mechanisms had to be stripped down, cleaned out and restored back to full working order so that a coin could slide through them freely.
All the mechanisms were also converted from a token pay-out (which they were on by law towards the end of being operated) back to the original currency denomination pay-out; 6 pence, old penny etc.









